Do you have to join two pipes and don’t know how? You don’t need an adapter, there are other methods to be able to do it effortlessly. Here are 4 infallible tricks to connect two pipes without resorting to an adapter!
Connecting two pipes without using the adapter is easy, just resort to one of the many effective and easy-to-perform methods to achieve this purpose. Here are 4 tricks to connect two pipes and without resorting to the adapter, saving so much money!
First trick to join two pipes
The first trick to connect two pipes without an adapter involves the use of a nipper, here’s how to do it:
- With a nipper cut the pipe in half;
- Cut a piece of pipe in half again;
- With the hairdryer you get the hot air on the end of a piece of pipe;
- While it is still soft, insert the other piece of pipe inside;
- Slide the one where you used the hair dryer for a few centimeters;
- You can stop when you notice that it has fitted well;
- When it hardens, remove it and apply glue to the end;
- Put the hose back on, let it dry and then cut it in the middle of the joint;
- Repeat the operation on the other side of the tube and then cut;
- Finally, file the ends on the sandpaper.
Seal the ends of the pipes with a piece of wire. The adapter to join two pipes is ready, you can thread them from both sides and they are ready to use.
Second trick
This second trick involves joining two ends of a hose to water. The two ends are the same en so you need a piece of pipe to make them join. Here’s how to do it:
- Take a steel round screw joint;
- Heat it over high heat;
- Take it with pliers and place it on a suitable surface;
- Insert a piece of 3/4 plastic pipe while it is still hot;
- Place the piece of screw in the water to let it cool;
- When it is cold, unscrew the bolt from the plastic hymn tube with the pliers;
- The pipe will have the same grooves at the end as the bolt;
- Heat up the bolt again and repeat with the other end of the pipe.
At this point, cut out the piece that comes out of the groove, put gaskets in the ends of the irrigation pipes and screw the piece of pipe on both. The water will not come out and the connection will be perfect.
Third trick to join two pipes
Is the irrigation pipe leaking water because there is a hole? Here is the solution to be able to make it work again and avoid buying another one. Here’s how to do it:
- Cut the pipe at the point where the leak is;
- Cut a piece of rigid pipe the size of the irrigation pipe;
- Put some clear glue and stick the stiff piece into the irrigation pipe;
- Do the same thing with the other side;
- Seal both ends with a plastic tie and pull the closure firmly;
- Trim off any excess parts.
The irrigation hose is ready to work again without the danger of water leaking out.
Fourth Trick
If the irrigation hose is leaking water because it is cracked, you can solve the problem in this way:Cut the hose where there is the slot from which it is leaking;
- Insert a small piece of plastic at the two ends that joins the two sides;
- On the outside, screw the two pieces provided in the package, equipped with two screws each;
- Screw both tightly until the inserted piece appears secure.
You have thus joined the two parts of the irrigation pipe and the water will no longer leak out. You will be able to use the hose for irrigation without problems and as you can see you have repaired the hose without buying the adapter.
With these 4 tricks you can connect any hose easily and in a few minutes, saving you from buying the adapter and therefore without spending any more money. You can choose one of the tricks described depending on the pipe you need to join.
